Bead & Butt Wall Panels

Choosing Size

Portrait (tall)
Use portrait when the panel needs to be taller than wide – e.g. floor-to-ceiling.

Landscape (wide)
Use landscape when the panel needs to be wider than tall – e.g. half-height walls, media walls, shelving.

Dimensions
All measurements are shown in millimetres (mm).
For half-height walls, we usually recommend around 1200mm high.
For exact finished sizes, choose Cut To Size so we cut to your exact mm.

Design direction
The panel pattern always runs vertically in both portrait and landscape.
To achieve horizontal lines, order portrait and install on its side.

Measuring Tips

• Walls are rarely perfectly straight - allow a few extra mm if needed
• Measure from the top of the skirting (not the floor)
• If there is coving, measure from the bottom of the coving
• Panels join seamlessly in almost all cases
• If joining two full-size sheets (2440×1220mm or 3050×1220mm) these may need a light trim for a perfect seamless join

Our classic Bead and Butt wall panels feature a subtle 6mm wide beaded groove, creating a timeless, traditional look. The narrow, evenly spaced grooves and soft rounded bead detail add texture and character, making bead and butt panelling ideal for both period and modern interiors.

Our Cut-to-Size Service ensures a perfect, custom fit for your project. Each beaded panel is precisely cut, saving you time, effort, and the expense of hiring a professional.

Get your bespoke bead and butt panels here: Cut-to-Size Wall Panels

Measure Your Wall
Start by measuring the area where your bead and butt panels will be installed. This helps you order the correct sizes from the outset. Panels can be trimmed on site, or you can use our cut-to-size service for a precise fit.

Prepare the Panels
Apply a primer to the bead and butt panels to create a smooth, paint-ready surface. This helps the paint adhere properly and ensures an even finish.

Paint the Panel
Choose your desired paint colour and apply it evenly across each panel, making sure the beaded grooves are well covered. Allow the paint to dry completely before installation.

Apply Adhesive & Fit
Apply a suitable panel adhesive to the back of each bead and butt panel. Position the panel carefully on the wall and press firmly into place. Use masking tape or temporary supports to hold the panels while the adhesive sets.

Check out our full step-by-step installation guide here.